Hog panel deck railing – To separate panel and rails: Put three or four spacers on the ground where the panel fence will be guaranteed. Place the panel on the blocks and adjust it between fence posts. Railway hanger bracket on the back of the panel should rest against or within a 1/4 inch of the posts. Mark the positions where the bottom of each rail hanger bracket fulfills it. Insert a rail bracket against the post so the bottom of the bracket is against one of the lines you made. Drill two 3/4 inch screws in the bracket. Connect a bracket for each line.
Push the rails in brackets on the panel picket fence. Lift the panel and lower it so that the rails fit into the rail brackets installed on posts. Drill 3/4 inch screws through the side of the bracket and rail to secure the panel. Remove the spacers, unless you set the posts in concrete, in which case you must leave spacers in two or three more days. To combined Panel and rails; Put a couple of spacers on the ground where the hog panel deck railing will be guaranteed.
Place the panel on top of the spacers, so rails butting against the sides of the two positions. To draw a line under the rails where they meet the posts, please use a pen. Draw a line at each end of the rail. Align the bottom of a rail bracket on one of the lines. Connect a suspension for each line. Slide the panel between fence posts and rail brackets. Drilling 3/4 inch screws through apertures in the side rail of the bracket and the rail. When all the tracks are safe removing spacers. And your separate and combine hog panel deck railing was done now.hog panel deck railing, livestock panel deck railing, cattle panel railing, cattle panel deck railing, hog panel railing, goat panel railing, wild hog deck railing, wood railings for front porches