Installation A Wall Mount Garage Door Opener – An automatic garage door opener makes driving in and out of the car easier. With just a push of a button will open or close the automatic garage door. The forward or reverse switch works with a combination of photo-eye system, push button / wall model and a wireless remote. The wiring for the eyes of the picture and the wall mount push button all walk back to the automatic garage door opener and are linked to the terminals on the garage door opener.
First steps for installation a wall mount garage door opener, Insert two 20-gauge wires of the transmitter eye, which is the camera system with an LED light on the front located 6 inches from the floor and connected to the rail of the door to the garage door opener terminals. Connect the ends of the wires to the pigtails coming out of the transmitter, using wire nuts. The terminals are labeled on the garage door opener and five screws “0” / m “4”. Perform two 20-gauge wires of the eye of the receiver, located on the opposite way from the door, to the garage door opener terminals. Connect the ends of the wires to the pigtails coming out of the transmitter, with the aid of the wire nuts. Turn one of the wires of the receiver to one of the wires of the transmitter, and a 6-inch piece of wire called a “FM,” together. Unscrew the nut from a thread on the twisted wire ends. Do the same with the other threads of the transmitter and receiver.
The next steps for installation a wall mount garage door opener; Unplug opened the garage door from the container. If the garage door opener is hard-wired, meaning that the thread of the main electrical panel is connected directly to the lock, turn off the breaker to the circuit. Connect to the pigtails to the terminal labeled “1” and the other labeled FM to the terminal “4.” Tighten the screws to secure the wires to the inputs. Run two 20-gauge wires from the location of the linked Push button on the wall to the garage door opener. Connect one wire to the terminal labeled “0” and the other wire to the terminal labeled “1”. Tighten the screws to secure the wires to the terminal. Connect the cables to the two entrances on the pressure switch. Tighten the screws to secure the wires to the push button. Next, closes the garage door opener back into the container or the breaker switch back to the main panel box. Test the operation of the garage door opener to make sure that the good working of the reverse safety function. The door must reverse if an object in the doorway.garage door opener