How To Hang Barn Door Track System – A sliding barn door is a unique and stylish way to provide privacy in the home. The hardware sliding barn door track system should include the following: 2 “track flat steel track joint brackets, spacers, screws, bolts, carriage bolts, suspension rollers, bottom roller guide and lower rollers. in this project, barn doors are built with 04.03 “boards tongue and groove celebrated with two half” thick vertical uprights and two horizontal rails (top and bottom) on both sides, for a total thickness of the frame 1- 3. 4″
To ensure the barn door track system for walls and support for heavy of barn door, cut a 1 “x 4” mounting plates of the same length but slightly wider than the track. Use drywall anchors, spacers and bolts for fixing the mounting plate. Installation of flat track for joining steel brackets adjusted to the manufacturer’s instructions. To allow the door can open to the entire width of the door of the room in need of cutting lines with a length twice the width of the door.
Then measure and drill holes with a metal cutting steel barn door track system where it attaches to the mounting plate and the wall. Use an awl or an ice pick to create a seat for the drill. Apply some cutting oil drilling in the hole to keep cool area. As for the hint system, Using lag bolts, track installation and spacers mounting board and the wall, making sure that the track is perfectly level. Place the suspension rollers to the door according to the manufacturer’s instructions using the supplied bolts carriage, washers and nuts. Use a socket wrench to tighten. With another person or two, place the guide rollers and lower rollers, and hang the door on the track.